Horizontal multistage centrifugal pump consists of two or more impellers. They are used in pumping services of moderate-to-high TDHs (total dynamic head). Each stage is essentially a separate pump.
All the stages are within the same housing and installed on the same shaft. Eight or more stages can be installed on a single horizontal shaft. Each stage increases the head by approximately the same amount. Multistage pumps can be either single or double suction on the first impeller.
All Pumps have been supplying and servicing horizontal multistage centrifugal pumps, such as Javelin Pumps, for over 40 years.
The JH, JHI series are non-self priming, horizontal multistage centrifugal pumps. The pump is close coupled to the motor and mounted on a base plate.
These pumps are built to AS/NZS 4020 Standard and are safe for drinking water.
This user friendly design makes the pump suitable for installation in small domestic and industrial water supply or transfer applications. The pump is fitted with a mechanical seal and common pump-motor shaft.
The JH and JHI series are non-self priming, horizontal multistage centrifugal pumps. The Pump is close coupled to an electric motor with a common shaft and mounted on a base-plate. This design makes the pump suitable for installation in the small domestic or industrial water supply systems. The pump is fitted with a mechanical seal and common pump-motor shaft.
JH - The discharge and suction chamber are made of cast iron. The other parts of pump in contact with the liquid are made of stainless steel.
JHI - All parts of the pump in contact with the liquid being pumped are made of stainless steel. EPDM or Viton elastomers are available as standard.
|Standard voltages||1 x 220~240 V 50Hz|
|3 x 220~240Δ/380~415Y V,50Hz|
|Rated speed||2850 rpm (50Hz)|
|Enclosure class||IP 54|
The pump is fitted with a totally enclosed, fan-cooled motor.
Liquid: Clean liquid without solid particles.
Liquid temperature range: 0 C ~ +90 C.
Maximum ambient temperature: +50 C.
The maximum operating pressure depends on the temperature of the pumped liquid.
|Max. Operating Pressure||JHI(1)2, JHI(1)4|
|10 BAR||0ºC + 40ºC|
|6 BAR||+41ºC to +90ºC|
|List of Materials|
|Q: Silicon carbide||E: EPDM|
|U: Tungsten Carbide||V:Victon|
|B: Carbon||C: Seal type|
|A: Seal Type|
|JH, JHI 2/4|
|Connection||JH, JHI||JH, JHI|
|Suction port||1 " BSP||1 1/4" BSP|
|Discharge||1" BSP||1" BSP|
|Drain hole, priming plug||3/8" BSP||3/8" BSP|
|1||Suction chamber||Cast iron|
|2||Pump head||Cast iron|
|7||Mechanical Seal||Silicon carbide / carbon|
|8||O-ring||EPDM or Viton|
|9||Drain and priming plug||Steel|